Assembly - Pro-Form 831.285840 User Manual

ASSEMBLY

Place all parts of the stepper in a cleared area and remove the packing materials. Do not dispose of the packing
materials until assembly is completed. Assembly requires the included allen wrench
screwdriver
PART CHART
Use the drawings below to identify the small parts used in assembly. The number in parenthesis below each
drawing refers to the key number of the part, from the PART LIST on page 10. The second number refers to the
quantity used in assembly. Note: If a part is not found in the parts bag, check to see if it has been
preassembled.
M10 Locknut (15)Ð8
M8 x 19mm Button
Head Bolt (21)Ð4
M4 x 12mm Console
1. Press a Stabilizer Endcap (13) onto each end of the
Long Stabilizer (8).
Attach the Long Stabilizer (8) to the indicated end of
the Base (2) with two M10 x 65mm Hex Head Bolts
(24), two Washers (25) and two M10 Locknuts (15).
, two adjustable wrenches
Screw (22)Ð4
and a rubber mallet
Washer (25)Ð4
M10 x 82mm Carriage Bolt (24)Ð4
M4 x 10mm Screw (28)Ñ8
1
13
8
25
24
4
, a phillips
2
15
15
13
25
.