Cisco MDS 9500 series Configuration Manual page 8

Hide thumbs Also See for MDS 9500 series:
Table of Contents

Advertisement

Using the Switch Setup Utility
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Configure the ntp server? (yes/no) [n]: no
Enter noshut (shut is the default) to configure the default switch port interface to the noshut state.
Step 16
Configure default switchport interface state (shut/noshut) [shut]: noshut
Enter on (on is the default) to configure the switch port trunk mode.
Step 17
Configure default switchport trunk mode (on/off/auto) [on]: on
Enter deny (deny is the default) to configure a default zone policy configuration.
Step 18
Configure default zone policy (permit/deny) [deny]: deny
Denies the traffic to flow for all members of the default zone.
Enter yes (no is the default) to enable a full zone set distribution (refer to the Cisco MDS 9000 Family
Step 19
CLI Configuration Guide).
Enable full zoneset distribution (yes/no) [n]: yes
You see the new configuration. Review and edit the configuration that you have just entered.
Enter no (no is the default) if you are satisfied with the configuration.
Step 20
The following configuration will be applied:
switchname switch_name
interface mgmt0
ip address mgmt_IP_address
subnetmask mgmt0_ip_netmask
no shutdown
ip default-gateway default_gateway
telnet server enable
no ssh server enable
no system default switchport shutdown
system default switchport trunk mode on
no zone default-zone permit vsan 1-4093
zoneset distribute full vsan 1-4093
Would you like to edit the configuration? (yes/no) [n]: no
Enter yes (yes is default) to use and save this configuration.
Step 21
Use this configuration and save it? (yes/no) [y]: yes
Caution
Cisco MDS 9000 Family Quick Configuration Guide
2-8
If you do not save the configuration at this point, none of your changes are updated the next
time the switch is rebooted. Type yes to save the new configuration. This ensures that the
kickstart and system images are also automatically configured.
Chapter 2
Initial Switch Configuration
OL-8251-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mds 9100 seriesMds 9200 series

Table of Contents