ProForm 15.5 s 831.28622.1 User Manual page 6

1.
To make assembly easier, read the
information on page 5 before you begin
assembling the elliptical exerciser.
Identify the Stabilizer (9) which has round
Endcaps (21) on the ends. While another per-
son lifts the front of the Frame (1), attach the
Stabilizer to the Frame with two M10 x 75mm
Carriage Bolts (34) and two M10 Nylon
Locknuts (33).
2. While another person lifts the back of the Frame
(1), attach the other Stabilizer (9) to the Frame
with two M10 x 75mm Carriage Bolts (34) and
two M10 Nylon Locknuts (33).
3. The Console (23) requires four 1.5V "D" batter-
ies (not included); alkaline batteries are recom-
mended. IMPORTANT: If the elliptical exercis-
er has been exposed to cold temperatures,
allow it to warm to room temperature before
inserting batteries into the Console. If you
do not do this, the console displays or other
electronic components may become dam-
aged. Remove the battery cover from the
Console, and insert four batteries into the
Console. Make sure that the batteries are ori-
ented as shown by the markings on the bat-
tery cover. Then, reattach the battery cover.
4. While another person holds the Console (23) in
the position shown, connect the console wire to
the Extension Wire (68).
Attach the Console (23) to the Upright (2) with
the four Console Screws (59) included with the
Console. Be careful to avoid pinching the
wires.
Attach the Water Bottle Holder (29) to the
Upright (2) with two M4 x 22mm Screws (63).
1
34
34
21
2
33
1
3
Batteries
4
Console Wire
59
2
6
21
1
9
33
33
34
9
23
Batteries
Battery
Cover
23
68
29
63