The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure, that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the...
Page 3
Congratulazioni per l’acquisto del mixer rd 62 fx! e con tutti i contatti in perfetta effi cienza, in modo da Per un impiego corretto del mixer seguite le istruzioni evitare inconvenienti come falsi contatti, rumori di riportate in questo manuale.
Page 4
62 fx 10. LEVEL 7. PRESETS Potenziometro per il controllo del livello del canale. Selettore che per la scelta dei PRESET del DSP interno. Consente di scegliere tra 16 diversi effetti: riverberi di varia natura, delay stereo e combinazioni di due effetti 5.
Page 5
62 fx 7. Pannello Posteriore (fi g. 4) 3. +48V Tasto per l’assegnazione dell’alimentazione PHANTOM 1. MAIN MIX OUTPUTS +48 Volt alle prese XLR dei canali di ingresso. Due connettori JACK sbilanciati (+4 dB). Sono i connettori delle uscite principali del mixer e inviano NOTA all’esterno il programma principale proveniente dal...
Page 6
62 fx RD62FX • SPECIFICHE TECNICHE SEZIONE LIVELLI & DATI CONNETTORI CANALE DI INGRESSO MONO da -10 a -50dB sensibilità Ingresso MIC XLR-F bilanciato 1.5 kOhms impedenza da +10 a -30dB sensibilità Ingresso LINE JACK bilanciato 10 kOhms impedenza ±15dB a 12kHz, SHELVING...
Page 7
1. Introduction fact probably cause annoying hum and noise. Check periodically that your cables are in good condition, Congratulations for having chosen the rd 62 fx correctly wired and with perfectly effi cient contacts: mixer! in fact many problems and drawbacks (false contacts To make the best use of the mixer, please read this ,ground hum, crackles, etc.) are caused by the use of...
Page 8
2-effect combinations (reverb + delay, reverb + chorus). The main parameters of each 2. C. ROOM OUTPUT effect are listed in the RD 62 FX PRESET LIST table Two unbalanced JACK connectors (0dB): send out the (page 9).
Page 9
62 fx 3. +48V 4. POWER +48V Phantom power supply buttons: activates +48V Mixer on/off switch. power supply on the MIC inputs of the MONO input 5. Power supply socket channels. NOTE When the PHANTOM power supply is needed, make...
Page 10
62 fx RD62FX • TECHNICAL SPECIFICATIONS SECTION LEVELS & DATA CONNECTORS MONO INPUT CHANNEL from -10 to -50dB Balanced sensitivity MIC/LINE input 1.5 kOhms XLR-F impedance Balanced from +10 to -30dB sensitivity LINE input JACK 10 kOhms impedance ±15dB @ 12kHz, SHELVING...
Page 16
Le informazioni contenute in questo documento sono state at ten ta men te redatte e controllate. Tuttavia non è assunta alcuna re spon sa bi li tà per eventuali inesattezze. Tutti i diritti sono riservati e questo documento non può essere copiato, fotocopiato, riprodotto per intero o in parte senza previo consenso scritto della GENERALMUSIC S.p.A.
Need help?
Do you have a question about the rd 62 fx and is the answer not in the manual?
Questions and answers