Toyota Venza 2013 Owner's Manual page 17

1-2. Opening, closing and locking the doors
Switching the door unlock function
■
It is possible to set which doors the entry function unlocks.
STEP 1
Turn the "ENGINE START STOP" switch OFF.
STEP 2
When the indicator on the key surface is turned off, press and hold
the key.
The setting changes each time an operation is performed, as shown below.
(When changing the setting continuously, release the buttons, wait for at least
5 seconds, and repeat
Multi-information
display
(TFT type only)
STEP 3
For vehicles equipped with an alarm:
To prevent unintended triggering of the alarm, unlock the doors
using the wireless remote control and open and close a door once
after the settings have been changed. (If a door is not opened
within 60 second after
again and the alarm will automatically be set.)
In case that the alarm is triggered, immediately stop the alarm.
(→P. 110)
36
VENZA_OM_OM73010U_(U)
or for approximately 5 seconds while pressing
.)
STEP 2
Unlocking function
Hold the driver's door han-
dle to unlock only the
driver's door.
Hold the front passenger's
door handle to unlock all
doors.
Hold either front door han-
dle to unlock all doors.
Beep
Exterior: Beeps three
times
Interior: Pings once
Exterior: Beeps twice
Interior: Pings once
is pressed, the doors will be locked
on