Troubleshooting - Electrolux EWF 1408 ME1 User Manual

When you drain the water with the
emergency drain procedure, you must
activate the drain system again:
1. Put 2 litres of water in the main wash
compartment of the detergent
dispenser.
2. Start the programme to drain the
water.
12.9 Frost precautions
If the appliance is installed in an area
where the temperature can be less than
0° C, remove the remaining water from
the inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 Introduction
The start of the appliance does not occur
or it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the
Authorised Service Centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
• Check the tap - The appliance does
not fill with water properly.
• Check drain filter - The appliance
does not drain the water.
• Check the door - The appliance door
is open or not closed correctly.
If the appliance is
overloaded, remove
some items from the
drum and/or keep
pressed the door and
touch the Départ/Pause
button at the same time
until the indicator
stops flashing (see the
following picture).
2. Close the water tap.
3. Put the two ends of the inlet hose in
a container and let the water flow out
of the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty,
install the inlet hose again.
WARNING!
Make sure that the
temperature is higher than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
• Water safety alert - The anti-flood
device is on. Disconnect the
appliance. Close the water tap.
Contact the Authorised Service
Centre.
• Unstable mains supply - The mains
supply is unstable. Wait until the
mains supply is stable.
• Detergent overdosing - Reduce the
detergent quantity.
WARNING!
Deactivate the appliance
before you do the checks.
ENGLISH 23