Table of Contents
Advertisement
TOC
Section 3: Sending Jobs to the XRn
A. TUTORIAL: COPY A CD OR DVD
Copy CD or Copy DVD can be used to copy any CD or
DVD master. This project reads the master disc from your
computer's drive to the hard drive of the XRn computer. The
master is stored in the Global Image format (*.gi) in a
temporary location on the XRn. The XRn uses this temporary
file to make all subsequent copies that are requested. The
master disc is read only once to create the initial temporary
file.
Recommended for: All CD, DVD or BDR types (Audio CD,
Data CD, Software Install Disc, Video CD, DVD, DVD-ROM,
DVD+/-DL, etc.). This is best used for single runs where you
will not need to make additional copies of the master disc a
later time.
1. Select Copy Project from the Starter Window or the New
Project Panel. A Copy Project sub menu will be displayed.
Choose Copy CD or Copy DVD. Step one of the Copy Disc
wizard will be displayed.
2. You will be prompted to place the disc you would
like to copy into the drive inside your computer. The tray
door will open automatically. Place the disc in the drive
and click OK.
3.
The XRn will close the drive and read the contents
of the disc. It will display disc type (CD/DVD) and
show the size of the disc in Megabytes. Verify this
information is correct and click the next arrow to continue.
INDEX
Sending Jobs to the XRn
11
Advertisement
Table of Contents
