Table of Contents
Advertisement
TOC
Section 2: Hardware and Software
Setup
This section will describe the step-by-step process of setting
up your unit. This includes information on how to load the
supplies (ink and disc media) necessary to start producing
discs.
A. HARDWARE SETUP
Step 1: Applying Power
•
Locate the power cord supplied with the unit.
•
Place one end of the power cord into the plug on the back
of the unit and
the other end
into a surge
protected
outlet.
•
Turn on the
power switch
located on the
back of the
unit above
the fan.
•
Unit will initialize for approximately 60 seconds.
Step 2: Installing Ink Cartridges
•
Using the LCD Control Panel access the Main Menu of the
XRn by pressing the
Choose "Install Cartridges"
•
Using the key provided, open the front cover of the unit.
The cartridge carrier will move to the
load position.
•
Open the ink cartridge covers.
•
Remove the ink cartridge from its
packaging.
•
Slowly remove the tape covering the cartridge's print head,
being careful to avoid damaging the barcode label on the
underside of the cartridge.
DO NOT TOUCH THE COPPER AREA!
Hardware and Software Setup
6
Setup
INDEX
Power Switch
button.
Advertisement
Table of Contents
