Pride Mobility SC40X Owner's Manual page 30

Pride mobility mobility scooter owner's manual sc40x
Hide thumbs Also See for SC40X:
Table of Contents

Advertisement

V I . C O M F O R T A D J U S T M E N T S
TILLER ANGLE ADJUSTMENT
WARNING! Remove the key from the key
switch before adjusting the tiller or the seat.
Never attempt to adjust the tiller or the seat
while the Travel Scooter is in motion.
Your Travel Scooter is equipped with an adjustable pivoting
tiller.
1. While supporting the tiller, turn the tiller adjustment knob
counterclockwise to loosen the tiller. See figure 15.
2. Move the tiller to a comfortable position.
3. Turn the tiller adjustment knob clockwise to secure the
tiller in position.
NOTE: In order to fully lower the tiller, you must first
remove the seat and battery pack. Remove the seat by pulling
it straight up and off of the Travel Scooter.
SEAT ROTATION ADJUSTMENT
The seat rotation lever, located on the right side of the seat
base, secures the seat into several positions.
1. Pull up on the seat rotation lever to disengage the seat. See
figure 16.
2. Rotate the seat to the desired position.
3. Release the lever to lock the seat into place.
ARMREST WIDTH ADJUSTMENT
The armrest width can be adjusted inward or outward.
1. Loosen the armrest adjustment knobs. See figure 16.
2. Use the attached ring to pull and remove the detent pins.
3. Slide the armrests in or out to the desired width.
4. Align the adjustment holes on the seat frame and armrest,
then reinsert the detent pin.
5. Tighten the armrest adjustment knobs.
NOTE: Pivot the armrests upward to aid in getting onto and
off of your Travel Scooter.
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to different heights. See figure 17.
1. Remove the seat and battery pack from your Travel
Scooter.
2. Use the attached ring to pull and remove the detent pin
from the lower seat post.
3. Raise or lower the upper seat post to the desired seat
height.
4. While holding the upper seat post at that height, align the
adjustment holes of the upper and lower seat post.
5. Fully insert the detent pin.
6. Replace the battery pack and seat.
30
www.pridemobility.com
TILLER ADJUSTMENT
KNOB
Figure 15. Tiller Adjustment Knob
DETENT PINS
ARMREST ADJUSTMENT KNOBS
Figure 16. Seat Adjustment
UPPER
SEAT POST
LOWER SEAT
POST
Figure 17. Seat Height Adjustment
SEAT ROTATION
LEVER
DETENT
PIN
Go-Go Ultra X

Advertisement

Table of Contents
loading

This manual is also suitable for:

Go-go ultra x

Table of Contents