Unpacking And Checking Equipment - Kenwood NX-700 Instruction Manual

One or more of the following statements may be applicable:
FCC WARNING
This equipment generates or uses radio frequency energy. Changes or modifications to this equipment may cause
harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose
the authority to operate this equipment if an unauthorized change or modification is made.
INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE FCC
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can generate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer for technical assistance.

UNPACKING AND CHECKING EQUIPMENT

Note: The following un packing instructions are for use by your KENWOOD dealer, an authorized KENWOOD service
facility, or the factory.
Carefully unpack the transceiver. We recommend that you identify the items listed in the following table before
discarding the packing material. If any items are missing or have been damaged during shipment, file a claim with the
c arrier immediately.
Supplied Accessories
Microphone (with cable)
Microphone hanger
DC power cable
•Fuse (15A)
Mounting bracket
Screw Set:
•5 x 16 mm self-tapping screw (4pieces)
•Hex-headed screw with washer (4 pieces)
•Spring washer (4 pieces
•Flat washer (4 pieces)
Instruction Manual
Item
)
NX-700-K FCC ID: K44378600 / IC: 282F-378600
Part Number Quantity
T91-0639-xx
J19-1584-xx
E30-7523-xx
F52-0024-xx
J29-0726-xx
N99-xxxx-xx
B62-××××-××
NX-800-K FCC ID: K44378700
1
1
1
2
1
1
1