Related Manuals for Godrej CELESTE
Summary of Contents for Godrej CELESTE
- Page 1 CELESTE User Instructions (Available in 2 sizes - 8 ltrs &14 ltrs) Be Intelligent. Be Safe.
- Page 2 TABLE OF CONTENTS Introduction......................2 1.1. Know your safe.....................0 1.2. Features........................0 1.3. Important instructions..................0 Mounting.......................0 2.1. Mounting tips and precaution................0 Typical Safe Operations..................0 3.1. Opening the safe....................0 3.2. Closing the safe....................0 3.3. Finger Placement....................0 3.4. Registering Fingerprints..................0 3.5. Deleting the registered fingerprints..............0 3.6.
-
Page 3: Introduction
1.INTRODUCTION 1.1 KNOW YOUR SAFE Start Button Mechanical Override key Biometric fingerprint reader Anchor Bolts Rubber cover for mechanical Power Indicator LED override keyhole 10) OK Indicator LED Motorized Shooting Bolts 11) NO Indicator LED Battery Compartment Reset/ Enroll button Note: Reset/Enroll Button is used to register and delete fingerprints. -
Page 4: Features
1.2 FEATURES Solid, arc-welded heavy-gauge steel construction 18 mm solid steel bolt for maximum security and durability Optical Biometric Fingerprint Sensor Fast and Accurate Verification Upto 32 Fingerprints Capacity Powered by 4*AA 1.5V Alkaline battery Low battery indication Interior Carpet Pre-drilled mounting holes 10) Mechanical Override key 1.3 IMPORTANT INSTRUCTIONS... -
Page 5: Mounting Tips And Precaution
2. MOUNTING Mounting through the bottom of the safe: • Check for the type of floor (wood, tile, concrete). • Get the appropriate anchors for the type of floor. • Check location on floor for concealed wires or pipes. • Mark the floor to drill for your anchor. -
Page 6: Typical Safe Operations
3. TYPICAL SAFE OPERATIONS 3.1 OPENING THE SAFE 3.1.1 BEFORE REGISTERING FINGERPRINT: (IN FACTORY DEFAULT CONDITION) 1. Press the Start Button, the power indicator LED will light up. A short beep will be heard and red LED from the fingerprint reader will be lit.. 2. -
Page 7: Finger Placement
fingers per user. Tips for different fingerprint conditions Godrej’s fingerprint products are designed to scan fingerprint smoothly regardless of the conditions of a finger skin. However, in case a fingerprint is not read well on the sensor, please refer to the followings tips. - Page 8 Note: 1. Finger should not be removed from the sensor until “OK” indicator LED lights up and a long beep is heard. 2. After registering 32 fingerprints, “OK” indicator LED will light up along with a short beep and then “NO”...
-
Page 9: Deleting The Registered Fingerprints
3.7 ERROR MESSAGES • Access denied condition: If the safe is tried to be opened using an unregistered fingerprint, “NO” indicator LED will light up three times along with three short beeps. • Error while opening and closing: If the shooting bolts failed to retract or extend fully then “NO”... -
Page 10: Information On E-Waste Handling And Management
These rules apply to every producer; consumer or bulk consumer involved in the manufacture, sale, and purchase and processing of electrical and electronic equipment or components as specified in Schedule 1 (please refer to our website www.godrej.com in the ‘Good & Green’ section of CSR module for more details). - Page 11 NOTES...
- Page 12 Toll-free: 1800 209 9955 | SMS 'GSS' to 53636 | Email: secure@godrej.com | Visit: www.godrejsecure.com In view of the Godrej policy of continuous development and improvement, the dimensions and specifications may be changed without prior notice or obligation. The colours of the product in leaflet may not match the actual colours due to printing limitations.
Need help?
Do you have a question about the CELESTE and is the answer not in the manual?
Questions and answers