Advertisement
ASSEMBLY INSTRUCTIONS
1
Attach two arms (A1) and (A2) to a seat (C) by
inserting the 4 ends of the front and rear crossbars
of the seat (C) into the holes of the arms (A1&A2) per
drawing. See Fig.1. Attach the two ends of the leg
connector (D) to the arms (A1 &A2). See Fig.2.
2
Line up the holes, insert a long bolt (Fc) through
a sleeve (Fe), through the left arm (A1) and secure
into the seat (C) for each hole. See Fig. 3. Do not
tighten completely. Repeat procedure for the other hole and the other side.
Align the holes. Insert a short bolt (Fa) through a metal washer (Fd), through the leg connector (D) and
secure into a right arm (A2) . Do not tighten completely. Repeat procedure for the other side. See fig.4.
Fd
Fa
3
Insert the pins of the back (B) into the arms
(A1&A2). See Fig.5. Align the holes on the
middle tube of the back (B) with the holes
on the rear crossbar of the seat (C). For
each hole, insert a medium bolt (Fb) through
a metal washer (Fd), through the rear crossbar
of the seat (C), and secure into the back (B).
See Fig. 6. Don't tighten completely. Repeat
procedure for the other side.
Fig.4.
A2
A1
D
A2
A1
C
D
Fig.5.
B
A2
A2
C
3
C
A1
C
C
D
A1
D
Fig.2.
Fe
Fc
Fig.3.
B
C
A1
D
A1
A1
Fig.1.
Fh
B
Fd
Fb
Fig.6.
Advertisement
