Troubleshooting - Panasonic WX-CT2020 Operating Instructions Manual

Order taker unit
Hide thumbs Also See for WX-CT2020:
Table of Contents

Advertisement

TROUBLESHOOTING

Phenomenon
The power indicator blinks in red.
The power indicator lights up in red
and a constant beep is heard in the
headphone.
Cannot turn on the order taker unit.
Cannot communicate with other
store personnel or the customer at
the menu board.
Cannot listen or talk to the
customer, while communications
with the store personnel are OK.
Cannot "page" or "talk" in certain
areas.
12
Possible Cause
A wrong channel is selected.
(The channel selector is set to the
wrong position. Refer to p. 7.)
The battery power is nearing its end.
The battery is exhausted.
The battery is not inserted correctly.
The center module may be turned off.
The vehicle detector may malfunction
because the detector is not plugged
into the center module, no power is
supplied, or the detecting function is
out of order.
Radio wave intensity is insufficient in
the areas.
What to do
Select any of channels 1 through 8.
If no remedy exists, consult your dealer
for repairs.
Recharge the battery.
Recharge the battery.
Position the battery properly. (Refer to p. 6.)
Turn on the power switch of the center
module. (Refer to the operating
instructions of the center module.) If no
remedy exists, consult your dealer for
repairs.
Check that the vehicle detector is
plugged in and is supplied power.
(Refer to WX-CC2010 Installation
Manual.)
If no remedy exists, consult your dealer
for repairs.
• Remove any metal obstacles blocking
radio waves, or try the following reme-
dy.
• Extend the transmission antennas.

Advertisement

Table of Contents
loading

Table of Contents