Battery Loading & Replacement - Panasonic WX-CT2020 Operating Instructions Manual

BATTERY LOADING &
REPLACEMENT
Notes:
• Refer to the operating instructions included with the
battery and battery charger.
• Prepare a fully charged battery.
• Battery replacement is recommended when the power
indicator lights up in red and a constant beep is heard
in the headset.
● Loading
Insert the battery as shown in the figure.
Note: Be sure to insert it until the lock clicks.
● Replacement
w
1. Slide the battery lock to the upside.
2. Remove the battery.
6
q
SETUP PROCEDURES
Caution: Setup of this product should only be performed
by qualified service personnel or system installers.
● Opening the Switch Pocket
1. Press the power button to turn off the order taker unit.
2. Open the switch pocket by moving the lid.
3. Set the channel selector and DIP switches. (Refer to
p. 7 "Channel Group Selection" and "DIP Switch Setup".
4. After finishing the setup, close the switch pocket by
moving the lid.
5. Turn on the order taker unit.
Notes: Be sure to turn off the order taker unit in Step 1.
Otherwise, the channel group (refer to p. 7 "Channel
Group Selection") will not be activated until you turn off
and on the power again.
w
● Turning the Power On/Off
1. Press the power button to turn on the order taker unit.
2. After using the order taker unit, press the power button
again to turn off the unit.
q