Custom Points Of Interest - Garmin zumo 340 Owner's Manual

You can purchase a new region or extend an existing
subscription at any time. Each region that you purchase has an
expiration date.

Custom Points of Interest

Custom POIs are customized points on the map. They can
contain alerts that let you know if you are near a designated
point or if you are traveling faster than a specified speed.
Installing POI Loader Software
You can create or download custom POI lists on your computer
and install them on your device using POI Loader software.
1
Go to www.garmin.com/extras.
2
Click Services > POI Loader.
3
Install the POI Loader onto your computer.
Using the POI Loader Help Files
For more information on the POI loader, refer to the Help file.
With the POI loader open, click Help.
Finding Extras
1
Select Where To? > Custom POIs.
2
Select a category.
Purchasing Accessories
Go to http://buy.garmin.com.
Troubleshooting
Problem Solution
My device is not • Verify the GPS simulator is turned off
acquiring satellite (page
signals.
• Take your device out of parking garages and
away from tall buildings and trees.
• Remain stationary for several minutes.
The suction cup will 1
Clean the suction cup and windshield with
not stay on my
rubbing alcohol.
windshield.
2
Dry with a clean, dry cloth.
3
Mount the suction cup
The device does not • Check the fuse in the vehicle power cable
charge in my vehicle. (page
• Verify the vehicle is turned on and is
supplying power to the power outlet.
• Your device can only charge between 32° F
and 113° F (between 0° C and 45° C).
My battery does not To maximize the time between changes, turn
stay charged for very down the backlight
long.
My battery gauge Allow the unit to fully discharge, and fully charge
does not seem it (without interrupting the charge cycle).
accurate.
How do I know my When your device is in USB mass storage
device is in USB mode, a picture of a device connected to a
mass storage mode? computer is shown on the device screen. Also,
you should see two new removable disk drives
listen in My Computer.
The device is 1
Disconnect the USB cable from your
connected to the
computer.
computer, but it will
2
Turn off the device.
not go into mass
3
Plug the USB cable into a USB port on your
storage mode.
computer and into your device.
The device automatically turns on and goes
into USB mass storage mode.
4
Verify your device is connected to a USB port
and not a USB hub.
16
13).
(page 2).
15).
(page 13).
Problem Solution
I cannot see any new If you have several network drives mapped on
removable drives in your computer, Windows can have trouble
my list of drives. assigning drive letters to your device drives.
Refer to your operating system Help file to learn
how to map or assign drive letters.
My phone will not • From the main menu, select Settings >
connect to the Bluetooth. The Bluetooth field must be set to
device. Enabled.
• Turn on your phone and bring it within 33 feet
(10m) of the device.
• Go to
help.
www.garmin.com/bluetooth for more
Appendix