Table of Contents
Advertisement
Quick Links
SECTION ONE
Consumer Protection Information
As manufacturers and suppliers of heating products, we take every care, as far as is reasonably
practicable, that these products are so designed and constructed as to meet the general safety
requirement when properly used and installed. To this end, our products are thoroughly tested
and examined before despatch.
IMPORTANT NOTICE: Any alteration that is not approved by the appliance manufacturer could
invalidate the approval of the appliance,
statutory rights.
Health and Safety Notice
Important
This appliance could contain some of the materials, indicated below, that could be interpreted
as being injurious to health and safety. It is the users / installers responsibility to ensure that the
necessary personal protective clothing is worn when handling these materials, see below for
information.
Artificial
Fuels, Mineral Wool, Insulation
may be harmful if inhaled, may be irritating to skin, eyes, nose and
When handling
facemasks and eye protection. After handling wash hands and other exposed parts. If
is used for cleaning the coals or cleaning after servicing / installation it is recommended that it
be of the type fitted with
Disposal
of refractory/ceramic
be securely wrapped in polythene and be clearly labelled 'RCF waste'. These materials are not
classified as 'hazardous waste and should be disposed of at a site licensed for the disposal of
industrial waste.
INTRODUCTION
The Excalibur Xtra is a decorative fuel effect appliance with a radiant heat conserver box for
improved
efficiency.
The Excalibur Xtra is available in two versions Natural Gas or LPG (Propane Gas Only). The
markings (G20 for natural gas or G31 for propane) on the packaging and the data badge specify
the gas for which the appliance has been factory
on
used
the appropriate gas specified. They are not suitable for conversion from one gas
to the other.
The Excalibur Xtra should be installed and serviced by a competent
registered, in accordance with the current Gas Safety (Installation and Use) Regulations 1998
(as
amended).
The chimney or flue (unless new) must be swept before installation if it has been used for solid
fuel or
oil.
Users Instructionsl
avoid inhaling and contact with skin or
a
HEPA
filter.
materials.
57901
operation of the warranty and could affect your
Material, Refractory/Ceramic
To keep dust to a minimum these materials should
set.
Note: These appliances should only be
Fibres, Glass Yarn -
throat.
eyes.
Use disposable
person Le. CORGI-
gloves,
a
vacuum
Advertisement
Table of Contents
Related Manuals for Excalibur xtra
Summary of Contents for Excalibur xtra
- Page 1 'hazardous waste and should be disposed of at a site licensed for the disposal of industrial waste. INTRODUCTION The Excalibur Xtra is a decorative fuel effect appliance with a radiant heat conserver box for improved efficiency. The Excalibur Xtra is available in two versions Natural Gas or LPG (Propane Gas Only). The...
- Page 2 Nat gas model which works with a pull and push knob allowing the adjustment of the flame picture. The Excalibur Xtra incorporates a safety device in the form of an Oxygen Depletion System, which constantly monitors the oxygen in the room and will cause the fire to switch off if the oxygen level reduces, for instance due to insufficient ventilation or a blocked flue.
- Page 3 - Users Instructions SECTION THREE Warning: -Before you clean any part of the appliance ensure that the appliance is turned off cool. CLEANING: DECORATIVE TRIM • The finish of the trim is coated with a high temperature lacquer, it can be wipe with a soft, clean, dry, cloth only.
- Page 4 Users Instructionsl SECTION FOUR Coal layout continued COAL BED LAYOUT Important: - Refer to the 'Heath & Safety Notice located on page 3 of this booklet before laying or replacing any refractory material. The coals are delicate and they should be handled with great care. It is important that all the coals and moulded shapes are positioned as shown in these instructions.
- Page 5 Users Instructionsl SECTION FOUR Coal layout continued Position a row of 5 square coals, with the flat face down, so that they sit on top of the oblong coals and rest against the front matrix as shown. With the flat face pointing downwards, lay a row of 4 square coals immediately behind the front row bridging the gaps in the front coal matrix.
- Page 6 Servicing It is advised that the Excalibur Xtra fire is serviced annually this is more likely to provide trouble- free operation. A competent person must carry this out, i.e. CORGI Registered Installer in accordance with the current Gas Safety (Installation and Use) Regulations 1998 (as amended).
Need help?
Do you have a question about the xtra and is the answer not in the manual?
Questions and answers