Table of Contents
Advertisement
1. Remove the pan supports to easily clean
the hob.
Be very careful when you
replace the pan supports to
prevent the hob top from
damage.
2. The enamel coating occasionally can have
rough edges, so be careful when you wash
the pan supports by hand and dry them. If
necessary, remove stubborn stains with a
paste cleaner.
3. After you clean the pan supports, make sure
that they are in correct positions.
4. For the burner to operate correctly, make
sure that the arms of the pan supports are
aligned with the centre of the burner.
Cleaning the hob
• Remove immediately: melted plastic,
plastic foil, sugar and food with sugar. If not,
the dirt can cause damage to the hob. Take
care to avoid burns.
Troubleshooting
WARNING!
Refer to Safety chapters.
What to do if...
Problem
There is no spark when you try to
activate the spark generator.
The flame extinguishes immedi-
ately after ignition.
The flame ring is uneven.
www.zanussi.com
• Remove when the hob is sufficiently
• To clean the enamelled parts, cap and
Cleaning the spark plug
This feature is obtained through a ceramic
ignition candle with a metal electrode. Keep
these components well clean to prevent difficult
lighting and check that the burner crown holes
are not obstructed.
Periodic maintenance
Speak to your local Authorised Service Centre
periodically to check the conditions of the gas
supply pipe and the pressure adjuster, if fitted.
Possible cause
The hob is not connected to an
electrical supply or it is connec-
ted incorrectly.
The fuse is blown.
Burner cap and crown are placed
incorrectly.
Thermocouple is not heated up
sufficiently.
Burner crown is blocked with
food residues.
cool: limescale rings, water rings, fat stains,
shiny metallic discoloration. Clean the hob
with a moist cloth and non-abrasive
detergent. After cleaning, wipe the hob dry
with a soft cloth.
crown, wash them with warm soapy water
and dry them carefully before you put them
back on.
Check if the hob is correctly con-
nected to the electrical supply.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Place the burner cap and crown
correctly.
After lightning the flame, keep the
knob pushed for equal or less
than 10 seconds.
Make sure that the injector is not
blocked and the burner crown is
clean.
Remedy
9
Advertisement
Table of Contents
