Table of Contents
Advertisement
equipment and receiver.
•
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
•
Consult the dealer or an experienced radio /
TV technician for help.
CONSUMER INFORMATION
a.
This equipment complies with Part 68 of the
FCC rules and the requirements adopted by
the ACTA. On the bottom of this equipment
is a label that contains, among other
information, a product identifier in the format
US:KT5W400BCU328. If requested, this
number must be provided to the telephone
company.
b.
An applicable certification jack Universal
Service Order Codes (USOC) for the
equipment is provided (i.e., RJ11C) in the
packaging with each piece of approved
terminal equipment. The mounting of the
approval unit in the final assembly must be
made so that the approved unit is isolated
from exposure to any hazardous voltages
within the assembly. Adequate separation
and restraint of cables and cords have been
provided
c.
A plug and jack used to connect this
equipment to the premises' wiring and
telephone network must comply with the
applicable FCC Part 68 rules and
requirements adopted by the ACTA. A
compliant telephone cord and modular plug
is provided with this product. It is designed to
connect to a compatible modular jack that is
also compliant. See installation instructions
for details.
d.
The REN is used to determine the number of
devices that may be connected to a
telephone line. Excessive RENs on a
telephone line may result in the device not
ringing in response to an incoming call. In
most but not all areas, the sum of RENs
should not exceed five (5.0). To be certain of
the number of devices that may be
connected to a line, as determined by the
total RENs, contact the local telephone
company. [For products approved after July
23, 2001, the REN for this product is part of
the product identifier that has the format
US:KT5W400BCU328. The digits
represented by ## are the REN without a
decimal point (e.g., 03 is a REN of 0.3). For
earlier products, the REN is separately
shown on the label].
e.
If this equipment CU328 causes harm to the
telephone network, the telephone company
will notify you in advance that temporary
discontinuance of service may be required.
But if advance notice isn't practical, the
telephone company will notify the customer
as soon as possible. Also, you will be
advised of your right to file a complaint with
the FCC if you believe it is necessary.
f.
The telephone company may make changes
in its facilities, equipment, operations or
procedures that could affect the operation of
this equipment. If this happens the telephone
company will provide advance notice in order
for you to make necessary modifications to
maintain uninterrupted service.
g.
Should you experience trouble with this
equipment, please contact Oregon Scientific
www2.oregonscientific.com/service/support
or call 1-800-853-8883 for repair or warranty
information. If the equipment is causing harm
to the telephone network, the telephone
company may request that you disconnect
the equipment until the problem is resolved.
h.
Please follow instructions for repairing if
needed (e.g. REPLACING THE BATTERY
section); otherwise do not alter or repair any
parts of THE device except where specified.
i.
Connection to party line service is subject to
state tariffs. Contact the state public utility
commission, public service commission or
corporation commission for information.
NOTICE If your home has specially wired alarm
equipment connected to the telephone line,
ensure the installation of this CU328 does not
disable your alarm equipment. If you have
questions about what will disable alarm
equipment, consult your telephone company or a
qualified installer.
NOTICE According to telephone company reports,
AC electrical surges, typically resulting from
lightning strikes, are very destructive to telephone
equipment connected to AC power sources. To
minimize damage from these types of surges, a
surge arrestor is recommended.
This equipment is to be supplied from an
identified USB port complying with the
requirements of Limited Power Source.
CAUTION
To maintain compliance with the FCC's RF
exposure guidelines place the base unit at least
20cm from the nearby persons."
Advertisement
Table of Contents
