Oregon Scientific CU328 User Manual

Important Saftey Instruction
Some of the following information may not apply to your
particular product; however, when using conference phone
equipment, basic safety precautions should always be followed
to reduce the risk of fire, electric shock and injury to persons,
including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the
product.
3. Unplug this product from the wall outlet before cleaning.
Do not use liquid cleaners or aerosol cleaners. Use a
damp cloth for cleaning.
4. This product should not be used while you are in a
bathtub, shower or pool. Immersion of the product in
water could cause an electrical shock.
5. Slots and openings in the cabinet back or bottom are
provided for ventilation, to protect it from overheating.
These openings must not be blocked or covered. The
openings should never be blocked by placing the
product on the bed, sofa, rug, or other similar surface.
This product should not be placed in a built-in
installation unless proper ventilation is provided.
6. This product should be operated only from the type of
power source indicated on the marking label. If you are
not sure of the type of power supply to your home,
consult your dealer or local power company.
7. Do not allow anything to rest on the power cord. Do not
locate this product where the cord will be abused by
persons walking on it.
8. Do not overload wall outlets and extension cords as this
can result in the risk of fire or electric shock.
9. Never push objects of any kind into this product through
cabinet slots as they may touch dangerous voltage
points or short out parts that could result in a risk of fire
or electric shock. Never spill liquid of any kind on the
product.
10. To reduce the risk of electric shock, do not disassemble
this product, but take it to a
when service or repair work is required. Opening or
removing covers may expose you to dangerous voltages
or other risks. Incorrect reassembly can cause electric
shock when the telephone equipment is subsequently
used.
11. Do not expose the product to extreme temperatures
such as areas near a hot radiator or stove or in a hot car.
12. Do not place lighted candles, cigarettes, cigars, etc., on
the telephone.
13. Never touch uninsulated telephone wires or terminals
unless the telephone line has been disconnected at the
network interface.
14. Never install or modify telephone wiring during a
lightning storm.
15. Never install telephone jacks in wet locations unless the
jack is specifically designed for wet locations.
16. Use caution when installing or modifying telephone lines
to prevent electrical shock and/or fire.
17. Unplug this product from the wall outlet and refer
servicing to qualified service personnel under the
following conditions:
A. When the power supply cord or plug is damaged or
frayed.
B. If the product has been exposed to rain or water.
C. If the product does not operate normally by following
the operating instructions.
qualified serviceman
D. If the product cabinet has been damaged.
E. If the product exhibits a distinct change in
performance.
18. Avoid using a telephone (other than a cordless type)
during an electrical storm. There may be a remote risk of
electric shock from lightning.
19. Do not use the telephone to report a gas leak in the
vicinity of the leak.
20. Do not place this product on an unstable cart, stand or
table. The product may fall, causing serious damage to the
product.
21. Plug the adaptor to the socket-outlet which near the
equipment and shall be easily accessible.
22. Risk of explosion if battery is replaced by an incorrect
type, use on 3SN-AA120H-S-J1. Dispose of used
batteries according to the instructions
23. For servicing or replacement, you can purchase a
suitable headset through service center or retailer shop.
(see in www. oregonscientic.com)
SAFETY TIPS
This product is designed to give you years of service if handled
properly. Observe the following guidelines:
- Clean the unit with a damp cloth and mild detergent. Avoid
dropping the unit or placing it in a high-traffic location.
- Never immerse the unit in water. This can cause electrical
shock and damage the unit.
- Do not subject the Base Unit to extreme force, shock, or
fluctuations in humidity.
- Do not tamper with the internal components.
- Do not mix new and old batteries or batteries of different types.
- Remove the batteries if storing this product for a long period of
time.
- Do not scratch the LCD display.
- Do not make any changes or modifications to this product.
Unauthorized changes may void your right to use this product.
- The technical specifications for this product and the contents
of the user guide are subject to change without notice.
CAUTION
To reduce the risk of fire, use only
No. 26 AWG or larger
telecommunication line cord.
CAUTION
You must use a Class 2 power source that provide in
package. Its plug must fit the phone power jack. The supplied
adapter meets these specifications. Using an adapter that does
not meet these specifications could damage the phone or the
adapter.
Always connect the AC adapter to the phone before you connect
it to AC power. When you finish, disconnect the adapter from AC
power before you disconnect from the phone.
Under the environment with electrostatic discharge, the
captioned model may malfunction and require user reset.
SAVE THESE INSTRUCTIONS