Table of Contents
Advertisement
HOW TO REPLACE THE SHAVER FOIL & CUTTERS
NOTE: Before replacing the shaver foil and cutters, be sure to turn off the shaver.
1.
Remove the foil assembly by gripping the head assembly release tabs on both
sides of the head and lifting the foil assembly upwards to remove from the hair
pocket.
2.
Grasp the cutters between the thumb and the forefinger and pull upward.
3.
Snap each of the new cutter assemblies into the top of the drive shaft. Do
not push on the ends of the cutters as this may bend them and reduce their
effectiveness.
4.
Insert the new foil assembly on top of the hair pocket until it snaps into place.
1.
3.
Vibrator
13
2.
4.
Vibrator
Advertisement
Table of Contents
