ONOSOKKI DS-2000 series Operation Manual page 7

3-3 Unit Conversion
It is inconvenient that the vibration waveform is still displayed as a voltage. Use the unit
calibration function to allow direct read from voltage to acceleration. Click the Input menu
and then select Unit / Calibration to open the dialog.
Input acceleration unit m/s2.
Thereby, the unit of CH1 (impulse hammer side) is converted to N (newton) for excitation
force, and CH2 (accelerometer side) to m/s
each unit.
Input hammer vibration force unit N (newton).
Set a voltage value (sensor
sensitivity) per unit.
2
for acceleration, enabling direct reading with
6
Click OK to confirm
the settings.