ONOSOKKI DS-2000 series Operation Manual page 2

1. Flow Chart to Measurement
The following explains procedures for measuring the frequency response function using an
impulse hammer.
Connect accelerometer and
impulse hammer.
• Set an input source.
• Set a sensor sensitivity.
• Set unit name.
• Adjust voltage range (Y-axis).
• Adjust frequency range (X-axis).
• Set trigger.
• Process data.
• Save data.
Contents
1. Flow Chart to Measurement
2. Device Connections
3. DS-2000 Setup
4. Measurement
1
Connect an
accelerometer and an
impulse hammer to the
DS-2000.
Set the type of the
connected sensor and the
data described in the data
sheet of the connected
sensor to the DS-2000.
Perform trial measurement
and adjust data to make it
legible.
Save and load data.