ONOSOKKI DS-2000 series Operation Manual page 3

2. Device Connections
Connect an "accelerometer" and an "impulse hammer" to the DS-2000. Although the
acceleration sensor comes in two types, built-in amplifier type and charge output type, the
use of the built-in amplifier type is assumed here. Connect each sensor with the DS-2000
series as shown below.
The following shows an example of direct connection of an impulse hammer without using
an amplifier. However, when output magnification is to be performed by the amplifier, input
the output from the amplifier of the impulse hammer to the DS-2000.
Excitation response
Waveform signal
2
DS-2000