GE WR30X10093 Installation Instructions Manual page 4

USE THESE INSTRUCTIONS FOR PLASTIC INTERIOR LINED
SIDE-BY-SIDE REFRIGERATORS ONLY
Installation
Instructions
These instructions apply to plastic interior lined side-
by-side refrigerators only. For Metal interior lined side-
by-side units refer to page 2. For top-freezer units refer
to page 6.
STEP 1 REMOVE THE ICE BUCKET
Ice Bucket
STEP 2 REMOVE THE EXISTING
ICEMAKER
The icemaker will be attached to the
icemaker bracket with Phillips head
or Hex head screws.
loosen and remove the 2
mounting screws.
NOTE: Remove screws
completely.
be retrieved when icemaker has been removed.
Bracket
ON–OFF
from socket
located on the
top of auger
motor housing.
Phillips Hex
Head Head
Mounting
Screws
by Pulling Them
Outward
a Flatblade
Screwdriver
Back Side
Bracket Mount Instructions
WR30X10093 & WR30X10102
STEP 3
REMOVE FILL CUP, ICEMAKER
INSERT AND PLASTIC STRIPPER PLATE
Fill Cup
To remove, gently pull out on the center of the plastic
to disengage the right end from the slot on the
opposite end. You may need to wiggle the stripper.
way, and replace with the original one.
Stripper Plate
STEP 4 INSTALL FILL CUP AND
ICEMAKER INSERT INTO NEW
ICEMAKER
cup from the old icemaker.
4
Fill Cup
Stripper Plate
Mold Body
31-49143-1