Remove The Ice Bucket & Chiller Shelf; Remove The Existing Icemaker - GE WR30X10093 Installation Instructions Manual

USE THESE INSTRUCTIONS FOR METAL INTERIOR LINED
SIDE-BY-SIDE REFRIGERATORS ONLY
Installation
Instructions
These instructions apply to metal interior lined side-by-
side refrigerators only. For Plastic interior lined side-
by-side refrigerators refer to page 4. For top-freezer
refrigerators refer to page 6.
STEP 1 REMOVE THE ICE BUCKET &
CHILLER SHELF
Non-Dispenser
Side-By-Side Bucket
Chiller Shelf
Dispenser
Side-By-Side Bucket
Bracket Mount Instructions
WR30X10093 & WR30X10102
STEP 2 REMOVE THE EXISTING
ICEMAKER
The icemaker will be attached to the
icemaker bracket with a Phillips head
or Hex head screws.
loosen the 2 mounting screws
until the screw heads extend
about 1/2" (13mm) from the
icemaker bracket.
NOTE: Do not
completely remove
the screws.
upwards so that the
screws are in the wide
part of the mounting
tab. Pull the icemaker
away from the
icemaker bracket.
icemaker, locate the restraints on each side of the
rear wall of the freezer.
2
Phillips Hex
Head Head
Mounting
Bracket
Screws
Mounting
Tabs
(Appearance may vary)
a Flatblade
Screwdriver to
on Back Side
by Pulling Them
Outward
31-49143-1