Table of Contents
Advertisement
C
O
M
M
E
R
C
11. Install the center handrail. Loosen the four fasteners in the handrail clamp
bracket with the hex key provided. See Diagram 9, #1. The center handrail is
packaged in two pieces. Install one side at a time by following these steps:
a. Insert a handrail end cap. See Diagram 9, #2.
b. Slide the end of the handrail into the center clamp and rotate the handrail
so that it falls inside the end cap. See Diagram 9, #3.
Diagram 10 Secure the display
console and center
handrail.
Center handrail
mounting bracket
(right side)
1-inch
screws (G)
with washers (D)
(right side)
Handrail end cap
screw (C) with
washer (F)
(left side)
c. Align the center handrail's mounting bracket with the holes in the upright
support. See Diagram 10, #1. Insert two 1-inch screws (G) with washers
(D) and finger tighten. See Diagram 10, #2. Do not securely tighten the
screws until both sides of the center handrail have been attached. See
Diagram 10, #1 and #2.
d. Align the mounting holes in the handrail with the end cap. Place a washer (F)
on screw (C) and insert the screw. Finger tighten. See Diagram 10, #4.
e. Follow steps 9a. through 9d. on the opposite side.
I
A
L
P
R
O
D
3
U
C
T
S
D
I
V
1
4
I
S
I
O
N
2
page 15
Advertisement
Table of Contents
