Testing Seat Clamp And Post Clamp Tightness; Front And Rear Reflector Installation - Huffy Coaster Owner's Manual

Testing Seat Clamp and Post Clamp Tightness

To test the tightness of the seat clamp and the post clamp:
WARNING:
red refl ector is correctly positioned.
• Try to turn the seat side-to-side and to move the front of the seat up and down.
• If the seat moves in the Seat Clamp:
• Loosen the Seat Clamp.
• Put the seat in the correct position and tighten the Seat Clamp tighter than before.
• Do this test again, until the seat does not move in the Seat Clamp.
• If the Seat Post moves in the Seat Tube:
• Move the Quick Release Lever to the "open" position.
• Put the seat in the correct position and tighten the Quick Release Lever tighter than
before.
• If necessary, loosen Quick Release Lever, tighten Adjusting Nut and re-tighten Quick
Release Lever.
• Do this test again, until the seat post does not move in the seat tube.
Refl ector Installation (as equipped)
Refl ector Installation:
1. Position FRONT Refl ector
straight forward.
2. Tighten Clamp Screw.
3. Position Seat Post Refl ector (if equipped)
B
so it points straight backwards.
4. Tighten Clamp Screw.
NOTE: Do not over-tighten. This will damage
the Clamp.
DUAL REAR REFLECTORS (VARIOUS MODELS):
The Rear Refl ectors
the bike chain stays. Make sure they are secure, not
bent and are pointing straight backwards.
Installation (as needed):
• Place Refl ector
tached with two supplied Screws
• Tighten securely. Do not over tighten.
14
Every time the quick release mechanism is loosened, make sure the
A
so it points
A
are may be pre-installed on
A
in position as shown and at-
B
1
.
B
B
A
A
2
B
3