Download Print this page

Ordering Information - Linx SI Keyfob Data Manual

Advertisement

Ordering Information

Ordering Information
Part Number
Description
OTX-***-HH-KF#-SI-xxx
SI Keyfob Transmitter
MDEV-***-HH-KF#-SI
SI Keyfob Development System
*** = 418 (Standard) or 433.92MHz
xxx = Color (Leave blank for standard black)
WHT = White
CRE = Red
CGY = Gray
Figure 3: Ordering Information
Electrical Specifications
Keyfob Electrical Specifications
Parameter
Designation
Power Supply
Operating Voltage
V
CC
Supply Current
l
CC
Power-Down Current
l
PDN
Transmitter Section
Transmit Frequency Range
F
C
OTX-418-HH-KF#-SI
OTX-433-HH-KF#-SI
OTA Modulation
Center Frequency Accuracy
Frequency Deviation
Data Rate
Environmental
Operating Temperature Range
1. Characterized, but not tested
Figure 4: Electrical Specifications
Min.
Typ.
Max.
Units
Notes
2.1
3.0
3.6
VDC
3.4
mA
5.0
nA
1
418
MHz
433.92
MHz
2FSK
–50
+50
kHz
59.05
kHz
9,600
bps
–40
+85
°C
1
2
Theory of Operation
The SI Series Keyfob Transmitter combines a high-performance
synthesized SoC transmitter with an on-board microcontroller input
interpretation. The transmitter's advanced synthesized architecture delivers
superior stability and frequency accuracy while minimizing the effects of
temperature and body proximity.
The Keyfob operates in the following manner: when a button is pressed
on the Keyfob, the transmitter and microcontroller are woken from sleep
mode. The microcontroller detects the logic states of the button data
lines. The button data line logic states are sent from the microcontroller
to the transmitter as a serial data packet. The transmitter SoC generates
a 42-byte encrypted packet and transmits a three-packet burst for each
button press throught the antenna and into fre space. On the receiver
side, a Si4355 checks the preamble, the sync bytes and the CRC of the
transmitted packet. If the packet is OK the receiver responds to the button
logic state data in the manner programmed into the receiver by the end
user.
The transmitter is compatible with the Silicon Labs Si4355 receivers using
the Silicon Labs Ember One-Way Link protocol.
3

Advertisement

loading