Honda Clarity Plug In Hybrid 2018 Owner's Manual page 17

SAFETY
Installing a Child Seat with a Lap/Shoulder Seat Belt
n
A child seat can be installed with a lap/shoulder belt in any rear seat or, if
absolutely necessary, the front passenger seat.
1. Place the child seat on the vehicle
seat.
2. route the seat belt through the
child seat according to the seat
manufacturer's instructions and
insert the latch plate into the
buckle. Insert the latch plate fully
until it clicks.
3. Slowly pull the shoulder part of
the belt all the way out until it
stops. This activates the lockable
retractor.
4. Let the seat belt completely
wind up into the retractor, then
try to pull it out to make sure the
retractor is locked. If you are able
to pull the shoulder belt out, the
lockable retractor is not activated.
Pull the seat belt all the way out
and repeat steps 3 – 4.
26 |
5. Grab the shoulder part of the seat
belt near the buckle and pull up to
remove any slack from the lap part
of the belt. When doing this, place
your weight on the child seat and
push it into the vehicle seat.
6. Make sure the child seat is firmly
secured by rocking it forward and
back and side to side; less than
one inch of movement should
occur near the seat belt.
7. Make sure any unused seat belt
that a child can reach is buckled,
the lockable retractor is activated,
and the belt is fully retracted and
locked.
To deactivate a lockable retractor,
release the buckle and allow the
seat belt to wind up all the way.
SAFETY
| 27