Honda Clarity Plug In Hybrid 2018 Owner's Manual page 10

SAFETY
Fastening a Seat Belt
n
Adjust your seat to the proper position (see page 47) and then follow the
below steps:
1. Pull the seat belt out slowly.
2. Insert the latch plate into the
buckle, then tug on the belt to
make sure the buckle is secure.
Make sure that the belt is not
twisted or caught on anything.
3. Position the lap part of the belt
as low as possible across your
hips, then pull up on the shoulder
part of the belt so the lap part
fits snugly. This lets your strong
pelvic bones take the force of a
crash and reduces the chance of
internal injuries.
4. If necessary, pull up on the belt
again to remove any slack, then
make sure that the belt rests
across the center of your chest
and over your shoulder. This
spreads the forces of a crash
over the strongest bones in your
upper body.
To release the belt, push the red
PreSS button then guide the
belt by hand until it has retracted
completely.
WARNING
Improperly positioning the seat belts can cause serious injury or death in
a crash.
Make sure all seat belts are properly positioned before driving.
12 |
Pull out
slowly.
Pull out
slowly.
Pull out slowly.
Correct
Seated
Posture.
Latch
plate
Latch
plate
Buckle
Buckle
Lap belt
as low as
possible.
Lap belt
as low as
possible.
Adjusting the Shoulder Anchor
n
The front seats have adjustable shoulder anchors to accommodate taller
and shorter occupants.
1. Move the anchor up and down
while holding the release button.
2. Position the anchor so that the
belt rests across the center of
your chest and over your shoulder.
SAFETY
Push
| 13