Stihl FB 131 Instruction Manual page 9

WARNING
The cutting attachment and deflector
must be properly tightened and in safe
operating condition. Inspect for loose
parts (nuts, screws, etc.) and for
cracked, bent, warped or damaged
blades. Replace a damaged blade or
deflector before using the power tool.
Keep the handles clean and dry at all
times; it is particularly important to keep
them free of moisture, pitch, oil, fuel mix,
grease or resin in order for you to
maintain a firm grip and properly control
your power tool.
WARNING
Check that the spark plug boot is
securely mounted on the spark plug – a
loose boot may cause arcing that could
ignite combustible fumes and cause a
fire.
WARNING
To reduce the risk
of personal injury
to the operator
from blade con-
tact and thrown
objects, make sure
your unit is
equipped with the
proper deflector,
skirt and handle.
FB 131
An arrow on the deflector shows the
correct direction of rotation of the cutting
blade.
The arrow on the deflector must always
face away from you, so that cuttings and
other debris will be diverted away from
the machine and your position (see
chapter "Working Techniques".)
For proper control and less fatigue
during operation, adjust the loop handle
to suit your size before starting work.
Starting
WARNING
To reduce the risk of serious personal
injury from fire, start the engine at least
10 feet (3 m) from the fueling spot,
outdoors only.
For specific starting instructions, see the
appropriate section of your manual.
Place the power tool on firm ground or
other solid surface in an open area.
Maintain good balance and secure
footing.
WARNING
To reduce the risk of injury from blade
contact, be absolutely sure that the
cutting attachment is clear of you and all
other obstructions and objects, including
the ground, because when the engine
starts at starting-throttle, engine speed
will be fast enough for the clutch to
engage and move the cutting
attachment.
Once the engine has started,
immediately blip the throttle trigger,
which should release the starting throttle
and allow the engine to slow down to
idle.
WARNING
Your power tool is a one-person
machine. Do not allow other persons in
the general work area, even when
starting.
WARNING
To reduce the risk of injury from loss of
control, do not attempt to "drop start"
your power tool. Drop starting means
pushing the machine away from the
operator, or allowing it to drop toward
the ground, while pulling on the starter
grip. This method is very dangerous
bescause you may lose control of the
machine.
WARNING
When you pull the starter grip, do not
wrap the starter rope around your hand.
Do not let the grip snap back, but guide
the starter rope to permit the rope to
rewind properly. Failure to follow this
procedure may result in injury to your
hand or fingers and may damage the
starter mechanism.
English
7