Electrical Connection - AEG BOBZDB User Manual

A
12.3 Installing the oven under
a work surface
Before the installation, connect the oven
to the electrical supply. Refer to

"Electrical connection".

During installation in
combustible matter, NIN
SEV 1000 and fire protection
guidelines and regulations
of the Association of
Cantonal Fire Insurance shall
be strictly adhered to.
1. Place the appliance in front of the
recess and connect the mains plug.
Make sure the cable is free when you
slide the appliance.
2. Push the appliance into the recess.
A = appliance, N = recess
A A
115 mm
A 567
20
mm
mm
N 560-568 mm
A 592 mm
3. Use a minimum of 2 screws to attach
the oven on the 2 sides (A).
When installing next to a wood-
fuelled boiler, a heat-proof and heat-
insulating plate must be mounted at
the height of the appliance and at
least 30 cm deep.
B
~50 mm
N 600
mm
180
A 595
mm
mm
442 mm
N min.
550 mm
A
12.4 Electrical connection
WARNING!
If service is required always
disconnect the appliance
from the power supply.
Use a power cable of H05VV-F or higher.
Install the appliance with a socket supply
line. If there is no socket supply line, the
fixed home electrical system must
include an isolating device with at least a
3 mm-contact separation to enable a
simultaneous and all-pole cut off from
the mains (according to NIN SEV 1000).
The customer must have a socket for the
electrical connection that is accessible
and outside the coordination room. The
length of the connection cable must be
approximately 120 cm with lines
connected directly to the mains.
Only a qualified person can
connect the appliance to the
electricity supply.
1. Do the electrical connections as in
the connection illustration.
Voltage: 400V
PE L1
1
2. Secure the cable grip.
ENGLISH 31
min. 20 mm
B
10
mm
A
20 mm
400V 2 ~
L2
2 3
5 4