Table of Contents
Advertisement
JBAT1: Clear CMOS (Reset BIOS) Jumper
There is CMOS memory onboard that is external powered from a battery located on
the motherboard to save system configuration data. If you want to clear the system
configuration, set the jumpers to clear the CMOS memory.
Resetting BIOS to default values
1.
Power off the computer and unplug the power cord
2.
Use a jumper cap to short JBAT1 for about 5-10 seconds.
3.
Remove the jumper cap from JBAT1.
4.
Plug the power cord and power on the computer.
EZ Debug LED: Debug LED indicators
These LEDs indicate the status of the motherboard.
Keep Data
(default)
CPU - indicates CPU is not detected or fail.*
DRAM - indicates DRAM is not detected or fail.
VGA - indicates GPU is not detected or fail.
BOOT - indicates the booting device is not
detected or fail.
Important
* All EZ Debug LEDs (include CPU, DRAM, VGA &
BOOT) will light up simultaneously while the CPU is
not detected or fail.
Clear CMOS/
Reset BIOS
Overview of Components
37
Hide quick links:
Advertisement
Table of Contents
