Advertisement
A) As in the case with the phase switch this step is easier
to perform with two people. Sit (or stand) in your preferred
listening position while another person pushes the button
immediately below the LEDs that mark the three different
crossover frequencies. Each time the button is pushed the
crossover will cycle to the next frequency first 80Hz (LED will
light up), then 100Hz, and finally 120Hz. The next push of the
button will light the 80Hz frequency again.
B) Choose the setting that sounds the best and leave the
crossover set to this frequency. This can be changed at any
time in the future and will not affect the operation of either your
SubWoofer or your LightSpeaker system.
Step 7: Setting the volume control.
Your Klipsch Wireless SubWoofer has a built in volume control
so it can be matched to different numbers of LightSpeakers.
The more LightSpeakers in the listening area the higher the
volume should be set.
+
+
+
+
+
SUBWOOFER 6.2.0
Model W 6.2.0
Designed in USA
Manufactured in China
POWER
CAUTION:
+
RISK OF ELECTRICAL SHOCK
USE IN DRY LOCATIONS ONLY
Tech Support: 1-800-KLIPSCH
+
+
+
+
Low Pass Crossover
80 Hz
100 Hz 120 Hz
+
+
Volume
Phase
Zone
Status
+
+
0°
180°
1
2
Pairing
CONFORMS TO
UL STD. 1993
CERTIFIED TO
CAN/CSA
STD. E968
CONFORMS
TO ANSI/UL
STD. 60065
CERTIFIED TO
XXXXXXX
CAN/CSA STD.
C22.2 No. 60065
ON
OFF
ATTENTION:
110 - 240 V AC 50/60Hz
+
RISQUE DE CHOC ÉLECTRIQUE
Utiliser Seulement Dans des
Endroits Secs
+
+
+
13
Advertisement
