Klipsch W60200 Owner's Manual page 10

C) On your LightSpeaker transmitter find and press the
"PAIRING Button" located on the back of the transmitter. The
status lights on the front of the transmitter will begin to flash.
Note: When these lights are flashing, your transmitter is
in pairing mode; and you have approximately 30 seconds to
complete the next two steps. If you are unable to complete these
steps, simply push the pairing button on the transmitter again.
D) Set the Power switch, located on the back panel of your
subwoofer, to "ON". While the lights are still flashing on the
transmitter, push the pairing button on the back panel of your
Klipsch Wireless SubWoofer. When the "STATUS" LED turns
from Red to Green the pairing will be complete.
10
Tech Support: 1-800-KLIPSCH
+
+
+
+
Low Pass Crossover
80 Hz 100 Hz 120 Hz
+
+
Volume
Phase Zone
+ +
+
0° 180° 1 2
SUBWOOFER 6.2.0
CONFORMS TO
Model W 6.2.0 UL STD. 1993
CERTIFIED TO
CAN/CSA
STD. E968
Designed in USA
CONFORMS
TO ANSI/UL
Manufactured in China
STD. 60065
CERTIFIED TO XXXXXXX
CAN/CSA STD.
C22.2 No. 60065
ON
POWER
OFF
CAUTION:
110 - 240 V AC 50/60Hz
+
+
RISK OF ELECTRICAL SHOCK
USE IN DRY LOCATIONS ONLY
+
+
+
+
Low Pass Crossover
80 Hz 100 Hz 120 Hz
+
+
Volume
Phase Zone
+ +
+
0° 180° 1 2
SUBWOOFER 6.2.0
CONFORMS TO
Model W 6.2.0 UL STD. 1993
CERTIFIED TO
CAN/CSA
STD. E968
Designed in USA
CONFORMS
TO ANSI/UL
Manufactured in China
STD. 60065
CERTIFIED TO XXXXXXX
CAN/CSA STD.
C22.2 No. 60065
ON
POWER
OFF
CAUTION:
110 - 240 V AC 50/60Hz
+
+
RISK OF ELECTRICAL SHOCK
USE IN DRY LOCATIONS ONLY
+
+
+
+
Status
+
+
Pairing
ATTENTION:
RISQUE DE CHOC ÉLECTRIQUE +
Utiliser Seulement Dans des
Endroits Secs
+
+
+
+
Status
+
+
Pairing
ATTENTION:
RISQUE DE CHOC ÉLECTRIQUE +
Utiliser Seulement Dans des
Endroits Secs