Hoover HW86-DPM-S User Manual page 10

MAINTENANCE
10
Removing and cleaning the nozzle
Remove both tanks. From upright
position tilt carpet washer back.
Rinse nozzle under
water to remove debris.
Removing blockages from the brush bar
Using a pair of scissors
remove any threads or
hair caught around the
brush bar.
Lift nozzle release clip, pull
nozzle forward.
Replace nozzle lining
up tabs. Push nozzle
until clicks into place.
Slide nozzle downwards
to release from tabs.
IMPORTANT: If the brush bars do not rotate
easily then the belt may not have been fitted
correctly. Make sure the belt is not twisted.
CAUTION: Always unplug the carpet
washer before performing any maintenance/
troubleshooting checks.