Advertisement
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
REMOVE PACKAGING
• Remove packaging, foam cushions, and bottom cardboard.
• Open the washer door and take out all the accessories
in the drum
• Use of washer with the foam cushion is strictly prohibited.
PLACEMENT OF UPPER WATER DRAIN HOSE
The height of the drain hose (A) should be between ~34 to 40".
Its diameter (B) should not be less than 1.20", and its flow capacity
should not be less than 40 L/Min.
Before starting the washer, users should properly hang the drain
pipe ~34 to 40" above the floor.
INSTALLATION OF WATER INLET HOSE
• Place the water inlet hose screw onto the tap.
• Tightly screw the other end of the hose to the water
inlet valve using the rubber seal ring inside.
NOTE:
When tightening the clamping nut, evenly
apply force and avoid twisting the water inlet valve to
prevent breakage of the water inlet valve joint.
FOR UPPER DRAIN SYSTEM ONLY
Clamping Nut
Water Inlet Hose
ONLY FOR WATER INLET HOSE WITH
DOUBLE THREADED SCREW
Foam
Cushion
Base
A
34 - 40"
B
8
Advertisement
