Adjusting The Speaker Volume - Sony STR-DE475 Operating Instructions Manual

Multi Channel Surround Setup
z
About speaker distances
This receiver allows you to input the speaker position in terms of
distance. However, it is not possible to set the center speaker
farther away than the front speakers. Also, the center speaker can
not be set more that 5 feet (1.5 meters) closer than the front
speakers.
Likewise, the surround speakers cannot be set farther away from
the listening position than the front speakers. And they can be no
more than 15 feet (4.5 meters) closer.
This is because incorrect speaker placement is not conducive to
enjoy the surround sound.
Please note that, setting the speaker distance closer than the
actual location of the speakers will cause a delay in the output of
the sound from that speaker. In other words, the speaker will
sound like it is farther away.
For example, setting the center speaker distance 3~6 feet (1~2 m)
closer than the actual speaker position will create a fairly realistic
sensation of being "inside" the screen. If you cannot obtain a
satisfactory surround effect because the surround speakers are
too close, setting the surround speaker distance closer (shorter)
than the actual distance will create a larger soundstage. (1 foot
corresponds to a 1 ms difference.)
Adjusting these parameters while listening to the sound often
results in much better surround sound. Give it a try!
18 GB

Adjusting the speaker volume

Use the r emote while seated in your listening position to
adjust the volume of each speaker
Note
This receiver incorporates a new test tone with a frequency
centered at 800 Hz for easier speaker volume adjustment.
1
Press ?/1 to turn on the receiver.
2
Press TEST TONE on the supplied remote.
You will hear the test tone fr
sequence.
3
Adjust the volume level so that the volume of the
test tone from each speaker sounds the same
when you are in your main listening position.
• T o adjust the balance of the fr
speakers, use the fr ont balance parameter in the
LEVEL menu (see page 31).
• T o adjust the balance of the sur
sur round left speakers, use the sur
parameter in the LEVEL menu (see page 31).
• T o adjust the volume level of the center speaker
press MENU </> to select the center parameter
Use MENU +/– on the r emote to adjust the level.
• T o adjust the volume level of the sur
press MENU </> to select the sur
Use MENU +/– on the r emote to adjust the level.
4
Press TEST TONE on the remote again to turn off
the test tone.
Note
The test tone cannot be output when the receiver is set to MULTI
CH IN.
z
You can adjust the volume level of all speakers at the same
time
Rotate MASTER VOLUME on the receiver or press MASTER
VOL +/– on the remote.
.
om each speaker in
ont right and fr ont left
round right and
round balance
,
.
round speaker ,
round parameter .