Lock Knobs And Swivel Handles; Dust Chute - Powermatic 2000 Operating Instructions And Parts Manual

Lock Knobs and Swivel Handles

Referring to Figure 4:
1. Thread the swivel handles (A) into the front and
side handwheels (C) and tighten with a 14mm
wrench.
2. Screw lock knobs (B) into the threaded
openings on the end of the shafts located in the
middle of the handwheels (C).
Note: Do not tighten the lock knobs all the way
at this time.

Dust Chute

Referring to Figure 5:
The Model 2000 comes equipped with a dust chute
and hose assembly (Inset 2) for use with a dust
collection system. If you do not intend to use a dust
collection system, the
disconnected and removed as described below.
To provide sufficient clearance for removal of the
dust chute:
1. Raise the blade height all the way up and set
the blade tilt to 0º (refer to Handwheel
Adjustments on page 14).
2. Remove the arbor nut and collar as described
in the Blade Installation/Replacement on page
12, steps 3-4.
Removing the dust chute:
3. Remove two socket head button screws (D, E)
with 4mm and 5mm hex wrenches respectively.
4. Through the opening on the left side of the
cabinet, remove the hose (Inset 1, 2) by
twisting and pulling back on the dust port (F).
Take the entire assembly (Inset 2) out through
the side opening.
Do not replace the arbor nut and collar at this time,
but proceed to the Blade Installation/Replacement
section (following page).
dust chute may be
11
Figure 4
Figure 5