Verifying Network Connectivity - Cisco 2010 Hardware Installation Manual

Performing the Initial Configuration on the Router
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
line aux 0
Example:
Router(config)# line aux 0
Step 4 See the tech notes and sample configurations to
configure the line for your particular implementation
of the AUX port.

Verifying Network Connectivity

This section describes how to verify network connectivity for your router.
Prerequisites
•
•
SUMMARY STEPS
1.
2.
3.
Cisco Connected Grid Routers 2010 Hardware Installation Guide
4-20
Complete all previous configuration tasks in this document.
The router must be connected to a properly configured network host.
enable
ping [ip-address | hostname]
telnet {ip-address | hostname}
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Starts the line configuration command collection mode for
the auxiliary line.
—
Chapter 4 Configuring the Router
OL-21559-01