Table of Contents
Advertisement
Chapter 4
Configuring the Router
Enter enable secret: password1
Step 5
Enter an enable password that is different from the enable secret password. This password is not
encrypted (and is less secure) and can be seen when viewing the configuration.
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: password2
Enter the virtual terminal password, which prevents unauthenticated access to the router through ports
Step 6
other than the console port:
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: password3
Respond to the following prompts as appropriate for your network:
Step 7
Configure SNMP Network Management? [no]: yes
Community string [public]:
A summary of the available interfaces is displayed.
Note
Current interface summary
Interface
GigabitEthernet0/0
GigabitEthernet0/1
SSLVPN-VIF0
Any interface listed with OK? value "NO" does not have a valid configuration
Select one of the available interfaces for connecting the router to the management network:
Step 8
Enter interface name used to connect to the
management network from the above interface summary: gigabitethernet0/1
Respond to the following prompts as appropriate for your network:
Step 9
Configuring interface GigabitEthernet0/1:
Configure IP on this interface? [yes]: yes
IP address for this interface [10.10.10.12]:
Subnet mask for this interface [255.0.0.0] : 255.255.255.0
Class A network is 10.0.0.0, 24 subnet bits; mask is /24
The following configuration command script is created:
hostname myrouter
enable secret 5 $1$t/Dj$yAeGKviLLZNOBX0b9eifO0 enable password cisco123 line vty 0 4
password cisco snmp-server community public !
no ip routing
!
interface GigabitEthernet0/0
shutdown
no ip address
!
interface GigabitEthernet0/1
OL-21559-01
The interface summary includes interface numbering, which is dependent on the router model
and the installed modules and interface cards.
IP-Address
unassigned
10.10.10.12
unassigned
Performing the Initial Configuration on the Router
OK? Method Status
YES NVRAM
administratively down down
YES DHCP
up
NO
unset
up
Cisco Connected Grid Routers 2010 Hardware Installation Guide
Protocol
up
4-5
Advertisement
Table of Contents
