Table of Contents
Advertisement
sale@ponpe.com
TEMPERATURE CALIBRATION
TEMPERATURE CALIBRATION
TEMPERATURE CALIBRATION
TEMPERATURE CALIBRATION
TEMPERATURE CALIBRATION
( ( ( ( ( f o r t e c h n i c a l p e r s o n n e l o n l y
f o r t e c h n i c a l p e r s o n n e l o n l y
f o r t e c h n i c a l p e r s o n n e l o n l y
f o r t e c h n i c a l p e r s o n n e l o n l y) ) ) ) )
f o r t e c h n i c a l p e r s o n n e l o n l y
All the instruments are factory calibrated for temperature.
Hanna's temperature probes are interchangeable and no temperature
calibration is needed when they are replaced.
If the temperature measurements are inaccurate, temperature recalibration
should be performed.
For an accurate recalibration, contact your dealer or the nearest Hanna
Customer Service Center, or follow the instructions below.
• Prepare a vessel containing ice and water and another one containing
hot water (around 50 ºC). Place insulation material around the
vessels to minimize temperature changes.
• Use a calibrated thermometer with a resolution of 0.1 ºC as a reference
thermometer.
• With the instrument off, press and hold down the CFM & SETUP
keys, then power on the instrument. The "CAL" tag will appear and
the secondary LCD will show "0.0 ºC".
• Submerse the temperature probe in the vessel with ice and water as
near as possible to the reference thermometer. Allow a few seconds for
the probe to stabilize.
• Use the ARROW keys to set the reading on the secondary LCD to that
of ice and water, measured by the reference thermometer. When the
reading is stable and close to the selected calibration point, "READY"
tag will appear and "CFM" tag will blink.
• Press CFM to confirm. The secondary LCD will show "50.0 ºC".
• Submerse the temperature probe in the second vessel as near as
possible to the reference thermometer. Allow a few seconds for the
probe to stabilize.
20
www.ponpe.com
Hide quick links:
Advertisement
Table of Contents
