Installation And Wire Connection; Before Starting; Cautions On Installation - Clarion FZ105BT Owner's Manual And Installation Instructions

INSTALLATION AND
CONNECTION

1. Before Starting

1. This set is exclusively for use in vehicles with
a negative ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery "
before starting. This is to prevent short circuits
during installation. (Figure 1)
2. General Cautions
1. Do not open the case. There are no user serviceable parts inside. If you drop anything into the unit
during installation, consult your dealer or an authorized
2. Use a soft, dry cloth to clean the case. Never use a rough cloth, thinner, benzine, or alcohol etc.
For tough dirt, apply a little cold or warm water to a soft cloth and wipe off the dirt gently.

3. Cautions on Installation

1. Prepare all articles necessary for installing the
source unit before starting.
2. Install the unit within 30 of the horizontal
plane. (Figure 2)
3. If you have to do any work on the car body,
such as drilling holes, consult your car dealer
beforehand.
o
Max 30
4. Installation the Source Unit
1. Place the mounting bracket into the instrument
panel, use a crewdriver to bend each stopper
of the mounting bracket inward, then secure the
stopper.
2. Wire as shown in Section 7) .
3. Insert the source unit into the mounting bracket
until it locks.
4. Take care of the top and bottom of the trim ring
and mount it so that all the hooks are locked.
Note: 1. Some car models require special mounting
kits for proper installation. Consult your
Clarion dealer for details.
2. Fasten the front stopper securely to prevent
the source unit from coming loose.
13
FZ105BT
" terminal
o
Figure 2
WIRE
Clarion
service center.
4. Use the enclosed screws for installation. Using
other screws can cause damage. (Figure 3)
Chassis
Max. 6 mm (M5 screw)
Figure 3
Console opening dimensions
7-3/16"
(182 mm)
Hole
Battery
Figure 1
Chassis
Damage