Operating The Appliance; Hob; Oven; Rotary Spit - Bosch HCB738357M Instruction Manual

Operating the appliance

en
1Operating the appliance
You have already learnt about the controls and how
p l i a n c e O p e r a t i n g t h e a p
they work. Now we will explain how to set your
appliance. You will learn about what happens when you
switch the appliance on and off, and how to select the
operating mode.

Hob

Switching the hob on and off
You can switch the hotplate on and off with the control
knobs.
Setting a hotplate
You can set the heat setting for the hotplates using the
hotplate control knobs. Press the control knob for the
required hotplate and turn it to the required heat setting.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
Hotplate temperature is regulated by the heat
Note:
switching on and off. The heat may also switch on and
off at the highest setting.
Large dual-circuit hotplate and extended cooking
zone
The size of these hotplates can be altered.
Switching on the large area
Turn the hotplate control to position 9 - where you will
feel a slight resistance - then continue turning to õ/ç
symbol = large dual-circuit hotplate or extended
cooking zone
Then immediately turn it back to the desired heat
setting.
Switching back to the small area
Turn the hotplate control to Û and reset.
The small dual-circuit hotplate is particularly good for
heating small amounts.
Caution!
Never turn the hotplate control beyond the õ/ç symbol
to Û.
14

Oven

Operating the oven
Switching on the oven
Always keep the appliance door closed when it is
Note:
in operation.
Turn the function selector to the desired operating
1.
mode.
Turn the temperature selector to set the desired
2.
temperature.
The oven switches on.
The indicator lamp is lit when the oven is heating up. It
goes out during pauses in heating.
The indicator lamp also lights up when the
Note:
function selector is in the off position and a temperature
is set. The oven only begins to heat up when an
operating mode is set.
Switching off the oven
Turn the function selector to the Û position.
1.
Turn the temperature selector to the Û position.
2.
The oven switches off.

Rotary spit

Preparing the rotary spit
Slide a retaining clip onto the rotary spit and screw
1.
on the handle.
Place the roast as close as possible to the centre of
2.
the rotary spit.
Use retaining clips to secure the roast in place.
3.
Use milled screws to secure the retaining clips.
4.