Table of Contents
Advertisement
Quick Links
MDP 50 OPERATING INSTRUCTIONS
PUMP
MDP 50
OPERATING INSTRUCTIONS
SAINT-GOBAIN PERFORMANCE
SAINT-GOBAIN PERFORMANCE PLASTICS
PLASTICS FRANCE
EADAC DES BERTHILLIERS
7301 Orangewood Avenue
F-71850 CHARNAY LES MACON
Garden Grove, CA 92841
Tel: 33. (0) 3 85 20 27 00
Tel: 1(714) 630 5818
Fax: 33. (0) 3 85 29 18 48
Fax: 1 (714) 688 2614
www.microelectronics.saint-gobain.com
Advertisement
Table of Contents
Related Manuals for SAINT-GOBAIN MDP 50
Summary of Contents for SAINT-GOBAIN MDP 50
-
Page 1: Operating Instructions
MDP 50 OPERATING INSTRUCTIONS PUMP MDP 50 OPERATING INSTRUCTIONS SAINT-GOBAIN PERFORMANCE SAINT-GOBAIN PERFORMANCE PLASTICS PLASTICS FRANCE EADAC DES BERTHILLIERS 7301 Orangewood Avenue F-71850 CHARNAY LES MACON Garden Grove, CA 92841 Tel: 33. (0) 3 85 20 27 00 Tel: 1(714) 630 5818 Fax: 33. - Page 2 INDEX Page I – General I.1 – Introduction I.2 – Materials I.3 – Operation description I.4 – Pump Data II – Quick Checklist II.1 – Shipment II.2 – Reception III – Installation and operation III.1 – Testing III.2 – Set up III.3 –...
- Page 3 Thank you for selecting a SAINT-GOBAIN PERFORMANCE PLASTICS model MDP 50 pump. I – General I.1 – Introduction The model MDP 50 is a pneumatically operated PFA/PTFE dosing pump. The pump is designed for dosing of chemicals. I.2 – Materials All wetted parts are manufactured from PFA and PTFE.
- Page 4 The pump is not damaged. If there are signs of damage you should report this immediately your • local distributor. The parts and operating instructions are included in the carton with the pump. • III – Installation and Operation III.1 – Testing All pumps are factory tested in our clean room for: Maximum and minimum stroke •...
- Page 5 For special applications call SGPPL or your local distributor. IV.3 – Cleaning The plastic design of the MDP 50 pump wetted parts allows the use of any cleaning materials. When flushing the pump, it is better to adjust it for maximum flow per stroke.
- Page 6 Problems which cannot be solved or with an unknown reason should be passed on to the manufacturer. the liquid conveyed might escape from the leak detection port in the event of a diaphragm rupture. ® Flaregrip II Saint-Gobain Performance Plastics registered trademark...
- Page 7 Chemical reactions in the product chamber of the pump (mixture of different substances) and the freezing of the liquid have to be avoided. Before putting the pump back into operation, the tightness of the pump has to be checked. ...
Need help?
Do you have a question about the MDP 50 and is the answer not in the manual?
Questions and answers