Getting Started; Operation - THOMSON ROC3506 Manual

5. Getting started

• Always use two AAA batteries.
• Remove the battery compartment cover
• Remove the USB receiver kept in the battery compartment. (Dongle shipment: attached inside the
box)
• Match the polarity markings on the batteries ( +/-) with those on the battery compartment.
• Insert the batteries.
• Replace the battery compartment cover
• If the power display [
the dead batteries in accordance with the disposal instructions.
Note
• The settings will remain stored on the remote control when you replace the batteries.
• Insert the USB receiver into a free, suitable USB port (for example, HID support) on the terminal
device (TV, set-top box, DVB-T/-C/-S tuner, PC or audio device).
• Switch on the remote control using the [ON/OFF switch]
Changing the preset connection mode
• The first time you switch on the remote control, TV modus is automatically enabled and a
connection is made to the USB receiver. If you wish to use the remote control with a different
terminal device, change the
If the connection to the remote control's USB receiver does not work automatically, please proceed
as follows:
• You can switch to PC mode by pressing the PC button
• Press and hold [ESC + K] at the same time for 5 seconds until the display flashes
LCD.
• When the display
different terminal device in the corresponding mode.
• To deactivate, press (FN+R) until
Note
Where possible, the TV will always switch on again (in standby mode) if the keyboard's wireless
connection to the USB dongle is enabled (manufacturer-dependent).
To prevent the TV from switching on unnecessarily, we generally recommend that you disable the
wireless USB transmission (FN+R) and enable it using the above-mentioned shortcut key (ESC+K)
only when required. By deactivating the wireless connection, you can also extend battery life (the
infrared functions will not be impaired).

6. Operation

6.1 PC mode
Windows keyboard functions
These functions may be possible, depending on operating system; or they may be possible on
different devices and to a different degree.
Example – Windows application:
MYKEY SUBTITLE
Example – Windows touchpad functions:
] flashes on the LCD
mode.
2
appears constantly on the
goes out on the display.
AVMODE TEXT RATIO
Single-finger swipe
Single tap
Two-finger swipe (horizontal or
vertical)
Pinch to zoom. Move two fingers apart to zoom in; move two fingers closer
together to zoom out.
on the bottom of the remote control.
8
on the remote control.
8
replace the two AAA batteries and dispose of
3
.
6
.
2
LCD , you are successfully connected to a
3
PORTAL MYAPPS AD
Mouse pointer control
Click at position of mouse pointer
Horizontal or vertical mouse movement
(scroll wheel)
on the
ENERGY TV/RAD SLEEP FAV
3
Q.MENU
3