Brother HL-L2310D Online User's Manual page 240

Level 1
Panel Control
Setting Lock
Interface
Replace Toner
[Printer]
For Printer Emulation Supported models
Level 1
Emulation
Print Options
2-sided
(For automatic 2-sided
printing models)
Auto Continue
Paper Type
Paper Size
Copies
Orientation
Print Position
Auto FF
HP LaserJet
Level 2 Level 3
Button -
Repeat
Message -
Scroll
LCD Contrast -
Auto Online
-
- -
Select -
Auto IF Time -
Input Buffer -
- -
Level 2 Description
- Choose the emulation mode.
Font List Print the font list and samples.
Test Print Print a test page.
2-sided Turn 2-sided printing off or on and select flip on long edge or short
Print edge.
Single Image For a print job where the last page is a 1-sided image, select the 1-
sided Feed option to reduce printing time.
- Select if you want the machine to clear paper size errors or media type
errors automatically.
- Set the type of paper.
- Set the size of paper.
- Set the number of printed pages.
- Set pages to print in either portrait or landscape orientation.
X Offset Move the print start position (at the top-left corner of pages)
horizontally up to -500 (left) to +500 (right) dots in 300 dpi.
Y Offset Move the print start position (at the top-left corner of pages) vertically
up to -500 (up) to +500 (down) dots in 300 dpi.
- Allow the machine to print any remaining data automatically.
Font No. Set the font number.
Font Pitch Set the font pitch.
The Font Pitch menu appears when you choose I012 to I018,
I031 to I037 or I097 to I109 in Font No. setting.
Font Point
Set the font size.
The Font Point menu appears when you choose I000 to I011,
I019 to I030 or I038 to I096 in Font No. setting.
Description
Set the time for the LCD message to change when
holding a or b at intervals.
Set the time in seconds that an LCD message will
scroll across the LCD. From Level 1=0.2 sec to Level
10=2.0 sec.
Adjust the contrast of the LCD.
Set the machine to return to Ready mode after it has
been idle for 30 seconds.
Lock your machine's settings using the Setting Lock
password.
Select the interface to use.
If you select Auto, the machine changes the interface
to USB or Network depending on which interface is
receiving data.
Set the time-out period for the auto interface selection.
Increase or decrease the input buffer capacity.
Sets the machine to continue printing after the LCD
displays Replace Toner.
236