Datalogic Dragon M101 Quick Reference page 11

DRAGON™ M SERIES
USING MULTIPLE READERS WITH SAME CRADLE
If you want to use several readers associated with the same cradle, you must
first Bind the cradle with one of the readers (see previously described
configuration procedure).
Successive readers can be associated with the same cradle by following the
configuration procedure substituting the Bind command with Join.
7.
The green LED on the Dragon™ M will blink: the reader is ready to be
inserted into the cradle. Complete step 8.
END of procedure.
If the cradle is not Bound to a reader, its address assumes
a random value which can cause conflicts and malfunctions
to other cradles within its range.
CAUTION
DRAGON™M/STAR-MODEM™ STAND ALONE SETUP
To configure a Dragon™ M reader to communicate with STAR-Modem™ in
Stand Alone Mode, follow the "Dragon™ M/OM-Dragon™ Stand Alone Setup"
procedure substituting steps 6 and 7 with those below:
6.
Read the code above and the four-digit address of the STAR-Modem™.
7.
END of procedure.
YOUR READER IS NOW READY TO READ BARCODES.
Join
Ì$+RN1$-NÎ
STAR-Modem™ Address
ÌRSRÎ
Exit and Save Configuration
Ì$-?Î
7