SEFRAM MW3105 Manual page 4

Symbols in this manual
This symbol indicates where cautionary or other information is found in the manual.
Battery
1.3 Front panel
Refer to figure 1 and the following steps to familiarize yourself with the instrument's front panel, controls and connectors.
1. Hz  F
. Test lead input for frequency, resistance, capacitance, continuity and diode test measurements.
2. Volt Plug . Positive (or high) test lead input for voltage measurements.
3. COM Plug. Black (common neutral, ground), low side test lead input.
4. Current Clamp Jaws. Use for current measurements without disconnecting circuit. Simply open jaws and loop around
conductor.
5. Lever. Press to open, or release to dose jaws.
6. Power/Function/Range Selector. Rotary switch to turn power off or to select measurement range and function.
4