Basic Operations - Recordex ST-700 Instruction Manual

Turning the IFP on or off
Plug the power cord into an AC Power outlet. Press Power Switch on the IFP.
1
Now the IFP is in standby mode. Wait a moment until the power indicator lights up, then press POWER
2
on the IFP. (Be sure to wait for a few seconds before pressing POWER button. If you promptly press POWER
button then the IFP may not respond or act wrongly.)
Press button again to turn off the IFP and put the IFP in standby mode.
3
To cut off the power completely, press Power Switch on the IFP.
Note: If the IFP does not receive a displaying signal for a certain time, the IFP goes into standby mode.
The first time installation
Connect to power source and turn on the IFP, the below installation menu page will display on the screen.
Operating the Float menu
Turn off the Float menu.
Call the application history.
Call the input source menu.

Basic Operations

Select desired menu
language, then press START
and turn to next page.
1.Slide up from bottom of the screen center by two or more fingers to call
Press and drag to any place of the screen.
2. Press to take 2 seconds to be activated on VGA/HDMI/DP/PC channel.
3.When displaying at USB interface, touch once at the lower part of the screen, the display
control menu will appear.
Call the annotation.
Call the Home page.(Android Interface)
Back to previous.
Call the Volume bar.
10
to turn
Select location and turn to
next page.
.